background image

Congratulations on the purchase 
of your new System 50, by Navtec.

Navtec Hydraulic Systems are an industry standard and have
been for more than a decade. The System 50 you’ve 
purchased represents the ongoing ergonomic and mechan-
ical design program Navtec has initiated to address the
changing needs of modern yachts and the people who 
sail them.

System 50 is designed for improved functioning at all levels
– operational, mechanical, and ergonomic. It also is
designed to accommodate a two-speed auto-pump or 
a hydraulic power pack. The end result is an advanced, 
flexible, intelligently designed hydraulic control system for
yachts 35 to 70 feet long.

About your 
new Navtec System 50
Hydraulic Control Panel.

w w w. n a v t e c . n e t

i n f o @ n a v t e c . n e t

351 New Whitfield Street • Guilford, CT 06437 USA • Tel (203) 458-3163 • Fax (203) 458-9291

Summary of Contents for System 50

Page 1: ...ern yachts and the people who sail them System 50 is designed for improved functioning at all levels operational mechanical and ergonomic It also is designed to accommodate a two speed auto pump or a hydraulic power pack The end result is an advanced flexible intelligently designed hydraulic control system for yachts 35 to 70 feet long About your new Navtec System 50 Hydraulic Control Panel www na...

Page 2: ... for at least 5 000 psi must be run from the valve on the central panel to each operating cylinder High pressure hose cylinders and boom vangs are available from your Navtec distributor If the panel is single function the hose or tube runs from fitting 3 If multiple function the hose runs from 1 of 4 ports on 4 way selector valve 4 For push pull cylinders when a 4 way valve is used this is differe...

Page 3: ...ow cylinder to return fully Check to be sure there is sufficient oil in the reservoir so that it won t run dry Step 6 Repeat above procedure for each cylinder and line Step 7 Check oil level do not overfill Adjusting the relief valve The relief valve 5 is factory set to approximately 4000 psi Adjustment is provided by the 1 25mm round threaded cap in the aluminum valve block at the back of the pan...

Page 4: ...selector valve must be positioned before pumping or releasing tension To position turn the selector valve handle in either direction to the desired function at rear of valve to which the appropriate hose is attached until you feel the knob click Function labels are available from Navtec at no charge Note The single function panel can be converted to the multi function panel at a later date The con...

Reviews: