Version 29.01.2021
HW: CAM(V100)/(V21)
RL4-MZD88
P
a
g
e
6
1.4.1.
Activating the front camera input (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
Description of the power supply output: see chapter “Power supply output”.
1.4.2.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed when switching through the interface’s video
sources. It is recommended to enable only the required inputs, disabled inputs will be
skipped when switching through the video-interfaces inputs.
1.4.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera.
If set to ON, the interface switches to its rear-view camera input
„Camera-IN“
while the
reverse gear is engaged.
1.4.4.
Activating the guidelines (dip 6)
If set to OFF, the guidelines will be shown on the display. If set to ON, the guide lines won’t
be visible on the display.
Note: If there is no communication between interface and the vehicle`s CAN-bus (several
vehicles aren’t compatible), the reverse gear guide-lines can`t be shown during the vehicle’s
operation, even if they once appear after having switched the system to powerless
Note: Dips 4, 7 und 8 are out of function and have to be set to OFF.
1.5.
Settings of the 4 Dip switches (CAN function - red)
Dip position down is ON and position up is OFF.
Navigation / System
Dip 1
Dip 2
Dip 3
Dip 4
All vehicles
OFF
OFF
OFF
OFF
For all vehicles, use the OFF position of all the 4 dip switches.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
