Version 14.06.2018
HW:
GD(V97)/(V33)
RL3-MBN55
P
a
g
e
6
1.4.1.
Enabling the interface’s video inputs (dip 2-3)
Only by dip switches enabled video inputs can be accessed by switching through the
interface’s video sources. It is recommended to enable only the required inputs. Disabled
inputs will be skipped while switching through the video interfaces inputs.
1.4.2.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.3.
Monitor selection (Dip 6-8)
Dips 6-8 customize the monitor-specific video settings which sometimes even vary within
head units of the same version, caused by different monitor specifications. It is necessary to
try all possible combinations while a working video source is connected to the chosen input
of the interface. One of the six combinations will show the best picture size and quality
(some may give no picture). It is possible to first hot plug through the dip combinations. If
there is no change of picture visible after trying all 6 options, retry and disconnect the 10pin
plug of the Quadlock connector between every change of the dip setting.
Note:
Dip 1 and 4 are out of function and have to be set to
OFF
!
1.5.
Settings of the 4 Dip switches (CAN functions – red)
All 4 dip-switches of the video interface have no function for
normal use and have to be set to OFF
(except W218 since 2018 –
see league table)
.
Dip position down is ON and position up is OFF.
Vehicle/Navigation
Dip 1
Dip 2
Dip 3
Dip 4
All vehicles
OFF
OFF
OFF
OFF
W213 since 2018
ON
OFF
OFF
OFF
After each Dip-switch-change a power-reset of the Can-box has to be performed!