11
Slide Tray
Loading and Installing the Slide Tray
The VideoMate 2250 will accept all 80 and 140 Carousel,
Ektagraphic and SAV slide trays. We recommend the 80
slide tray for maximum reliability.
1. Check that the base plate of the slide tray is locked
into the zero position and cannot be rotated.
2. Load the slides upside down for normal front projec-
tion. Replace and lock the cover to prevent damage
in case the tray is dropped or turned over.
3. Place the loaded tray into its zero position on the
projector’s transport ring. The cleft on the slide tray
(zero position) fits into the notch of the transport ring.
Before you switch on the projector, please make sure
that the tray setting switch is in the correct position.
Tray Positioning Index Mark
Projectors are often installed on racks where tray instal-
lation may be difficult and only possible from the rear of
the projector. In this case, the tray positioning mark on
the back of the projector is very helpful: The tray is
properly set when the index mark aligns with the mark
placed on the tray (at slide #20 of the 80-slide tray and at
slide #35 on the 140-slide tray).
Camera Alignment
The following illustration shows the image orienta-
tion adjusting screws on the bottom of your
VideoMate projector.
The four screws marked “A” are used to shift the image
on the monitor left or right. Loosen (do not remove) the
four screws and apply pressure to one of the screw
