Position References
Figure 8.1: Numbers of UTM zones
AUTOPOS mode
To set values in different coordinate systems the dialogs represented on figure 8.2 are used:
(a) Geo
(b) Local N/E
(c) UTM
Figure 8.2: Value set up for different coordinate systems
NOTE!
Using the UTM system an operator can enter a zone number, different
from the one specified in the system. It’s convenient, if it’s required to
enter the known point coordinates, i.e. in map zone different from the
current one.
8.1.1
Target Offset
If the Target mode is available an operator can entry the offset it in meters. The offset is in N/E system in all cases
whatever coordinate system is used in MAP View.
Waypoints in the different coordinate systems
Waypoint dialogues for different coordinate systems are represented on figure 8.3.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
140
