Navico Simrad I3005, Operator'S Manual

Page: 29 / 52

Ú
Note:
AIS transponders typically operate at NMEA 0183-HS
(high speed), and will require the baud rate to be set to 38,400.
NMEA 2000 installer notes
Used to identify a device in the NMEA 2000 device list.
Serial input sentences
This list allows control over which sentences that are received from
other devices from the NMEA 0183 port.
Serial output sentences
This list allows control over which sentences that are transmitted to
other devices from the NMEA 0183 port. Due to the limited
bandwidth of NMEA 0183 it is desirable to only enable the data that
is required. The less sentences that are selected, the higher the
output rate of the enabled sentences.
View serial input
Used to confirm that the port setup is correct.
System Function ID (SFI)
A unique SFI must be assigned to each port that is to be part of the
LWE network.
If no SFI is entered (remaining with the default 0000 value), the
device will not be visible on the LWE network, and it will not share
any data.
Configure analog port
Used for defining the data source, the input type for the selected
source, and for calibrating the source.
The dialog options vary with selected data source and input type.
Software setup | I3005/I3007 Operator Manual
29