Navico NAC-2, Commissioning Manual

Page: 14 / 44

Autopilot installation dialog, AP48
Auto/Standby
Select this mode if you have a toggle button connected to your
NAC-2 autopilot computer. Press the button to toggle between
Auto and Standby mode.
Disengage
Select this mode if you have a disengage switch connected to your
NAC-3 autopilot computer.
• OPEN – Normal operation, can be controlled by controller.
• CLOSED to OPEN – Activates Auto mode regardless of previous
state.
• CLOSED – Disengaged. Cannot be controlled by controller.
SteadySteer
Select this mode if you have a SteadySteer connected to your
NAC-2/NAC-3.
• Manual steering overrides the active mode.
• If Auto mode or NoDrift mode was active before going into
manual steering, they will automatically re-engage when the
vessel has stabilized on a new course.
• For any other modes, the autopilot goes into Standby mode.
• If NAV mode was active before going into manual steering a
dialog will be shown.
- Confirm course change to reactivate NAV mode.
- Cancel the course change to activate Auto mode on the new
heading.
• If no action is taken the autopilot will go into Standby mode.
14
Dockside setup | NAC-2/NAC-3 Commissioning Manual