Navico NAC-2, Commissioning Manual

Page: 13 / 44

Dockside setup
Data source selection
Before commencing with autopilot computer setup the data
sources must be available and configured.
Data sources selection is required on initial start-up of the system, if
any part of the network has been changed or replaced, or if an
alternative source is made available for a given data type and this
source has not been selected automatically.
You can let the system automatically select your sources, or set up
each source manually. Refer to documentation for the autopilot
controller or for the display unit for details about how to perform
the data source selection.
Input function
Determines how the autopilot computer/system reacts to an
external input. External input can be connected to blue/yellow wire
on NAC-2 and mode/function selector on NAC-3. For wiring details
and options, refer to the installation documentation.
Autopilot installation dialog, MFDs
2
Dockside setup | NAC-2/NAC-3 Commissioning Manual
13