SF-3050 Quick Start Guide
96-310033-3001, Rev. E
3 of 4
24. Click
(refresh) on the
Firmware Info
window to
display the installed options.
25. Browse to the NavCom\Firmware folder on the PC. The
Firmware folder is copied from the SF-3050 Product
Configuration USB Flash Drive. It contains the
most
current firmware
. The firmware file extension is *.s19.
Open the Readme.txt file for additional
information.
26. Compare the current NAV Firmware version in the
Firmware folder with the installed version displayed in
the
Firmware Info
window
In the example above, the NAV firmware in the
receiver is not current and must be upgraded.
27. Perform one of the steps below.
•
If the NAV firmware installed in the receiver is the
most current version
, go to the
Upload Software
Options
section.
•
If the NAV firmware installed in the receiver is
not
the
most current version:
•
Check the versions of the other firmware.
•
Write down all the firmware that must be updated.
•
Go to the
Upload Firmware
section below.
Upload Firmware
Upload a Unified File
28. Select
Unified File Loader
on the
File Upload
window:
29. Click
and browse to NavCom\Firmware on the PC
and select a
unified
firmware file to upload.
30. Click
. The options to be uploaded are checked
on the
Ready to Downline Load File
window.
StarUtil 3000 will auto-read the reciever and select files
to load. Check or uncheck firmware files if necessary
(based on existing loaded version numbers).
31. Click
and the upload progress window
updates.
32. When the upload is complete, click
Close
.
33. If any file failed to upload, refer to the section “Upload a
Single Firmware File” in Chapter 3 of the StarUtil 3000
User Guide.
Do not close StarUtil-3000. Continue to the next
section.
Upload StarFire License
For this initial configuration, the StarFire license
must be installed via data cable. Subsequent
renewals of the license are typically transmitted to
the receiver via radio broadcast. Refer to the SF-
3050 User Guide.
The receiver must be tracking GPS satellites and
providing a valid position solution at the time of
the StarFire license upload to accept the license.
NAV Firmware
Firmware Info Window
Click the
Refresh
Button
NAV Firmware
Firmware in Receiver
Current NAV Firmware
Click the
Refresh
Button
