BHM
09/11/14
NTV-DOC191
rB3
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
This guide is intended for 5” Radio models, DO NOT USE FOR 8.4” radio models!
UCT-PRG Installation / programming
for
5” radio models
1.
Verify the key is in the OFF position (or not inserted) until step 6.
2.
After removing the factory radio, gather the
Plug & Play T-harness
and
connect the female side to the factory 44-pin plug. Make certain the lock
connects together securely.
3.
After installing a rear camera, connect the signal RCA to the
yellow RCA
on
the
male side (side going into monitor)
of the Plug & Play T-harness. The
other side of the
yellow RCA
can be left disconnected.
*If the harness is
shipped with the Audio (red & black) RCA’s disconnected, be sure to plug
the audio RCAs together. If left disconnected, the factory AUX audio jack
will not pass through.
4.
Connect the UCT-PRG module to the 18-pin connector found in the Plug
& Play T-harness.
5.
Connect the radio to the male side of the
Plug & Play T-harness
. Reconnect all
other plugs to the radio (see diagram on page 5).
6.
Turn the key to the
ON
position (don’t start vehicle).
7.
The radio will turn on, and restart itself within 1 minute.
8.
Re-cycle the key one time (turn key to
OFF
then back again to
ON
). Wait for the radio to
boot and settle.
9.
Cycle the ignition (off to ON) 3 times (1 cycle/sec). Verify the odometer is not flashing.
10.
If programming of the radio took successfully, the camera image (or blue screen) will
display on screen while in reverse.
LED Response
Description
1 flash
Waiting for Ignition…
(Turn ignition to ON)
3 flashes
VIN Mismatch
(This module has been used in a different vehicle already)
4 flashes
First time programmed
(Recycle ignition, then test for proper operation)
6 flashes
Programming complete
(The radio has accepted the program)
Below is a chart referencing LED flashes which can be found on the side of the
UCT-PRG module. Refer here for troubleshooting.
Proper LED flashing indication: 1
st
Key cycle: 4 flashes
2
nd
and every following key cycle: 6 flashes
