BHM
08/15/14
NTV-DOC188
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
2 |
P a g e
Installation
1.
Remove the factory radio, disconnect all harnesses and set the radio aside.
2.
Install the provided camera on the trunk lid/bumper.
3.
Connect the provided
Plug & Play Harness
to the
camera and run the 4-pin plug side forward to the
dashboard opening.
4.
DO NOT USE THE PROVIDED POWER BARREL located on
the camera extension harness!
Use the provided
separate
Cam Power Harness instead.
5.
Connect the
red
wire from the provided Cam Power Harness to an ACC 12v (+) source
from behind the radio (usually a gray wire,
TEST!
). Connect the
black
wire to chassis
ground (-).
The radio must see the camera upon vehicle startup in order for the screen to flip
to the camera’s image when in reverse. You MUST connect the camera to an
accessory/ignition source and not a reverse light for proper operation!
6.
Connect the 4-pin plug on the provided
Plug & Play Harness
to the
connector shown here. It is keyed and will only fit in one direction:
Note: If this radio does not possess the 4-pin plug, find the 24-pin
plug. You will need the Optional 24-pin adapter (NTV-ASY116)
available from NAV-TV.
7.
Perform this step only if this vehicle requires the
24-pin adapter (see step 5). The adapter
provided (24-pin plug) is only a reference: You
must remove the 4 wires from this adapter and
re-populate each pin into the factory plug in the
same locations. Removing these pins will require
prying the lock-tab up. Connect the 4-pin
camera harness to the 4-pin adapter.
