LOCATION & REMOVAL
INSTALLATION
The i-POD can be accessed via the CDC button on the
front unit. Menus, listings and tracks are found under
the CD list and CD track menu (via Audio button) and
operated with the right hand round button. Detailed
operating instructions are as follows;
Use the right hand round button to select CD LIST (fig
1), the menu will then appear for you to select from
playlists, artists, albums etc (fig2), when you have se-
lected your chosen field by pushing the right hand
round button the screen will revert back as fig1, you
then need to wait for your chosen field to appear in the
orange box (below CD 1 2 3 4 5 6) and for the CD
number to change, once it has appeared you may use
the same button to select the TRACK LIST option (fig
4) to then choose your playlist, artist, album etc. To
play your chosen track or album you will now need to
select “play selection” via the CD list option.
The factory track skip will skip, tracks, artists, gen-
res, albums etc depending on what you have se-
lected in the orange box.
The numbered buttons can also be used to di-
rectly select track numbers, e.g. press 1 then 2 to
go to track 12 etc. Shortcut buttons are as follows;
-Hold button 2 for Playlists
-Hold button 3 for Artists
-Hold button 4 for Albums
-Hold button 5 for Genre
OPERATING INSTRUCTIONS
Installation can be made at the factory CD changer or
at the front unit location.
You will need to access the orange fiber optic cables
(BLACK PLUG) that is plugged into the front unit or CD
changer; this may require you to remove the CD
Changer.
Remove the BLACK plug from the CD changer that con-
tains the orange fiber optic cables and insert it into the
POR-i-POD interface, plug in the i-POD loom to the inter-
face and route to desired location. Next supply a 12v+ Per-
manent supply to the Red cable and suitable Earth to the
Black cable and plug into the interface (if fitted at the CD
Changer location). The interface can also be fitted at the
front unit as diagram below shows using the supplied
black joiner to connect the fiber optics end to end at
the CD changer plug in the boot to continue the loop,
and using the supplied Plug in Power harness at the front
unit plug.
If there is no CD changer you will need to connect the fiber
optic cable supplied into the plug at the front unit to create a
loop as shown.
