Radio Removal and Installation (Cont.)
Radio Dash Images (Cont.)
9. Connect the Media dock USB connector to the
USB connector on the back of radio.
10. Connect the Media dock cable into radio side of
T-harness.
11. Plug in the fiber connector into the radio side of
the T-harness and connect to the radio.
12. Run the Dock harness from the radio inside of
the center console, and remove the center
factory armrest tray. Connect the dock harness
to the media dock and the media dock USB
cable to the media dock and secure the new
dock tray below the center console armrest.
If equipped with Bose System:
Run (2) White mic wires from the interface T-
harness up the passenger side “A” pillar to the
vehicle overhead console and connect them to
the two unpopulated slots on the 4 pin connector
(See image) to enable factory mic. (White to
White / Black to Black)
If Non-Bose System:
The Non-Bose system
does not have a Microphone in the stock vehicle.
We have microphones available for an additional
purchase.
Reinstall Dash in reverse order.
8 Pin Molex wiring guide
8 Pin Molex connector image
1. CAN High to vehicle (Yellow wire)
2. CAN Low to vehicle (Blue wire)
3. Chassis ground (Black wire)
4. +12V output to camera (White/Red wire)
5. CAN High to radio (Yellow wire)
6. CAN Low to radio (Blue wire)
7. +12V Constant power (Red wire)
8. +12V output for camera switcher (White/Blue)
Run (2) White mic wires
from T-harness to center
overhead console and
plug in to the two
unpopulated slots on the
4 pin connector to
enable factory mic.
NOTE: Bose equipped
vehicles only.
2 |
P a g e
