BHM
04/23/18
NTV-DOC314
3 |
P a g e
Wire Side
AUDI
Bentley
Bentayga
Porsche
See Below
*This remote wire must be used for aftermarket amplifier remote for proper functionality.
If installing more than
one amplifier/DSP, a relay must be used for reliable turn-on (500mA max).
VW
ZEN-V Installation
1.
If this vehicle has a factory amplifier, it must be removed and the ZEN-V can be installed into its place.
If this vehicle is not amplified from factory, install the ZEN-V behind the radio.
2.
Connect the following wires from the
provided
power harness
:
3.
Before connecting power to the ZEN-V,
adjust dip-switch settings for the desired options:
4.
If using analog RCAs for signal to the amplifier, connect according to the reference chart below.
WARNING: Do not connect RCA cables to this interface until all amplifiers/external processors are
properly grounded. Failure to do this may cause damage to the interface and VOID the warranty!
1
2
3
4
5
6
7
8
9
10
11
12
Left
Front
Right
Front
Left
Front
Right
Front
Left
Front
Right
Front
Left Rear
Door
Right Rear
Door
Left Rear
Center
Right Rear
Center
Center
Sub
5.
If using TOSLink for signal to the amplifier, connect the cable to the TOSLink port shown on page 2.
NOTE: both Analog and Digital output sound simultaneously, regardless of which type is used.
6.
Connect the provided
MOST Fiber Cable
from the
(previously removed) amplifier, or from the radio’s
fiber port to the MOST port on the ZEN-V.
ZEN-V pin
Color
To vehicle:
1
Yellow
12v (+)
Constant
3
Violet
--Reserved, NOT USED--
4
Black
Ground (-)
6
Blue
12v (+) remote output*
Time Alignment
Attenuation
TOSLink DownMix
Loudness
Vehicle Settings
Position
DIP 1
DIP 2
DIP 3
DIP 4*
DIP 5
DIP 6
UP
(off)
Front Row
Full Scale
output (0 dB)
DownMix ON
Loudness OFF
DOWN
(on)
Driver Focused
-12 dB output
DownMix OFF
Loudness ON
DIP 5
DIP 6
X
X
DIP 5
DIP 6
X
X
DIP 5
DIP 6
X
X
DIP 5
DIP 6
X
X
