BHM
03/02/17
NTV-DOC291
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
GVIF-Volvo Installation
1.
Remove the factory screen, and radio (CD player). Connections for this installation
require both locations to be accessible.
2.
Behind the screen, locate the OEM
blue
GVIF video connector. Connect the provided
GVIF-OUT Cable
to the screen where the OEM video cable was connected previously.
3.
Connect the other end of this provided cable to the interface at the port labeled
‘VIDEO
OUT’
.
4.
Connect the OEM video cable to the provided
GIVF-IN Cable
. Connect the other end of
this provided cable to the interface at the port labeled
‘VIDEO IN’
.
5.
With the provided
Power/CAN Harness
, Connect the following
wires to the radio’s main power plug:
a.
Black wire
to
PIN 15 (ground)
b.
Red wire
to
PIN 12 (12v constant)
c.
Blue wire
to
PIN 3 (CAN HIGH)
d.
White wire
to
PIN 4 (CAN LOW)
6.
Optional:
If desired, the
green wire
may be used as a trigger for forcing rear camera or
AUX video input (see OSD menu settings)
7.
Optional:
The purple wire may be used to power a (single) rear camera (12v + reverse
ONLY, 500 mA MAX )
8.
Optional:
Connect the provided
AUX Video Input cable
RCA to the port labeled
‘AV IN’
if
adding a front camera or aux composite video input.
9.
Connect the main Power/CAN harness to the interface at the proper port.
10.
Reconnect all plugs to the radio and screen and proceed to
‘GVIF-Volvo Operation’.
Wire side
NOTE: CAN2 wires (orange & green) are NOT used for this installation.
