BHM
04/13/15
NTV-DOC207
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
6 |
P a g e
Module Installation
1.
With the screen removed, locate the main 16-pin
connector that powers the screen. Connect this plug to
the female side of the provided
Plug & Play T-Harness
.
2.
Connect the provided
SMB-RCA Adapter
to the
screen at the port (typically purple) closest to the
M.O.S.T Fiber Optic connector.
Note: if there is already a connector here, disconnect
it and use the provided SMB Adapter instead.
3.
Connect the male end of the provided
Plug & Play T-Harness
back to the monitor at the 16-pin port.
4.
After installing your camera(s), run the signal and power through the car to the radio opening.
5.
If only installing a single camera, connect the signal RCA directly to the
SMB-RCA
Adapter
. When complete, skip to step 7.
Note: if vehicle possess an OEM reverse camera and you’re adding a front camera only, use the
provided Fakra-RCA adapter to retain this camera. See diagram on page 8.
