100 NW 11
th
street, Boca Raton, FL 33432
Tel. 561-955-9770 Fax. 561-955-9760
www.nav-tv.com
NTG3 2.10.09 Moni
Rev. 1.5 Tony Yankovsky
Remove Radio
Fig. 1 - Radio Removal (GL)
1. Remove 2 TORX T20 Screws behind ashtray,
unplug and remove ashtray.
2. Using a plastic trim tool, carefully pop out A/C
control trim, Then unplug.
3. Remove 2 TORX T20 screws below radio, then
move metal locking tabs DOWN.
4. Pull radio out and unplug.
NTG3 / NTG3E /NTG3SLK
Installation Instructions
Wiring - NTG3
Fig. 2 - Plugs at rear of Radio
1. Unplug factory power connector from radio.
2. Remove Fiber connector from factory plug by
releasing the latch and pulling the connector
outwards. Plug Fiber connector into supplied plug
and play harness connector.
3. Plug in the NTG3 adapter harness to factory harness,
Radio and NTG3 Module.
4. If adding Rear-view Camera: Plug video cable to
Green FAKRA, Connect to Camera.
5. Plug supplied A/V harness into Black 18-pin
connector. connect as needed: A/V out, AUX Video in,
Secondary (RSE) Audio in.
6. For your convenience, The following OUTPUTS are
included. DO NOT EXCEED 500mA !!!
White / Purple: +12V VIM Mode, 500mA
White / Green: +12V Acc. OUT, 500mA
(connect to Camera or turn on for RSE)
NOTE: The 3.5mm Audio jack in the glovebox is shared for both AUX modes, AUX
Audio and AUX VIDEO. If installing an additional A/V source such as Video ipod, Rear
DVD Player etc., the AUX Audio port will be occupied.
We advise to use the secondary AUX Audio Labeled “REAR” on the
AUDIO Menu as a substitute AUX Audio source and run a new 3.5mm jack
or Stereo RCA
!
s to the glovebox (Jacks not included).
Please inform your customer of the changes if needed.
Camera Video
Green FAKRA
NAV-TV