Nav TV BMW56 Manual Download Page 2

BMW56 Interface Connectors 

 

        

  Dip Switches           Key Pad               RGB(In)               A/V (In/Out)                                    Power 

 

                          CAN I/F                           LCD – Out                                                   LCD – In         Mode   LED 

Installation 

1. 
2.  Connect the F-Type connector supplied with the BMW56 into the LCD-Out port on

Plug in the LVDS vehicle connector into the LCD-In port on the BMW56 interface. 

 the BMW56.  Connect the other 

end of the F-Type plug into the port on the navigation screen where you removed the factory plug. 

Connect the CAN harness wires to the CAN wires on the Display Power and CAN harness. The CAN wires are 

e screen. NOTE: 

strip back the 2 CAN wires and wrap and solder the 2 CAN wires from the BMW56 CAN harness to the ve

ILURE IN VEHICLE.

 

3.  Connect both black wires leading off the main power harness to the BMW56 to chassis ground 
4.  Connect the red wire labeled “ACC Wire” to +12v accessory power source. 

5. 

Yellow/CAN Low, Black/ CAN Hi in the second harness with the black plug/gray lock behind th

hicle CAN 

wires. DO NOT CUT THE VEHICLE CAN WIRES- THIS MAY CAUSE CAN FA

Dip Switch settings 

Power connector pinout 

Disconnect BMW56 Power plug before making any 
DIP switch changes. 

 

Switch 1 – This is for the unused “NAVI” plug and can be 
flipped into down position to turn it off. 
Switch 2 – AV 1 
Switch 3 – AV 2 
Switch 4 – Leave in the Down position. 
Switch 5 – Screen size select: Up for 6.5 inch screen, and 

p – OEM rear camera.  Down - external rear 

Pin 1 – Ground (Black)
Pin 2 – i-Drive (Orange) 
Pin 3 – FMTX antenna (Blue) 
Pin 4 – N.C. 
Pin 5 – ACC (Red) +12v accessory power. 
Pin 6 – Rear (Gray) Connect to reverse lights for +12v 
trigger for back-up camera 

 

Down for 8.8 inch screen. 
Switch 6 – LCD type (fuse along with switch 5) 
Switch 7 – U
camera 
Switch 8 – Not used (leave in the up position)

 

Source Select 

To switch sources use menu button on console. (You must hold menu button for 3 seconds to change 
source). 

OSD Keyboard functions 

OSD Keyboard 

Menu – OSD Menu, Going back to last step of 
setting after mode setting. 
SEL – Select, Mode change. 
UP – Move to Left, Up. 
Down – Move to Right, Down. 

 

*Factory Mode – Operated with 
UP=>DOWN=>UP=>Menu keys of the keypad

 in 

sequence.

 

Agreement: 

End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. 

If you do not agree, please discontinue use immediately and return product to place of purchase. 

This product is intended for off-road use and passenger entertainment only.

 

2 | 

P a g e

 

 

Reviews: