Nautronic NG12, Service Manual

Page: 36 / 76

NG12 Board Zone
SW 2.15
Documentation of
How board zone works in NG12
Revision: 1
February 13, 2014 Page 3
It is important that the scoreboard is turned on and within range of the Naucon-1000 when pressing accept.
The addresses on the scoreboard are only used as identification of the scoreboard for diagnostics and for setting the
zone for a scoreboard. It is the zone selection that determines which scoreboards are receiving communication. The
zone selection is still required if you are using the system wired.
Note if an address of a scoreboard is not highlighted to one of the zones it will keep its current setting. By default
scoreboard is set to zone 1.
A Zone is a group of Scoreboards that are
controlled by the same Naucon-1000.
Picture of the default setting of the board zone
setup, for software version 2.15
2.4 Board zone selection
To enter the Board zones selection, do the following:
1. Exit to the Select sport menu.
2. Enter the General Setup.
3. Enter the Board Zone Selection Menu.
The Board zone selection menu selects which Zone the Naucon-1000
must control.
If all Zones are set to On , the Naucon-1000 unit will
control all Scoreboard Systems that are within range.
If for example Zone 1 is selected, the Naucon-1000
unit only controls Scoreboard Systems in Zone 1.
34