Nautilus Schwinn 450, Service Manual, Page: 9 / 23

9
Replacing the Pedals and Legs
!
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet and the
machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure location.
Tools Required: 6 mm hex wrench, 13 mm wrench
1. Using a 6 mm hex wrench, remove the 3 indicated bolts from below the Pedal.
2. Using a 6 mm hex wrench, remove the indicated bolts from the Pedal and Lower
Handlebar Arm.
Be aware that the Handlebar Arms will be loose and may pivot when the
hardware is removed.
3. Remove the Pedal.
4. Using a small Standard Screwdriver, pry up the Cap from the Crank Arm.
5. Using a #13 mm wrench, remove the indicated bolt from the Pedal and remove
it.
6. Repeat steps on opposite side.
7. Installation is the reverse procedure.
8. Discard the old parts.
9. Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and inspected for
correct performance in accordance with the Owner’s Manual.
6mm
X1
13 mm
X3
6mm
X2
13 mm