NS-700
11
step
8
Step #8 Materials:
#
Component
Qty
36
Pulley Bracket
1
50
Guide Rod Holder
2
51
Guide Rod
4
52
Top Weight
2
53
Selector Stem
2
55
Weight Stack Bottom Plate
2
56
Weight Stack Bumper
4
66
Weight Plate
38
86
Cap Head Allen Screw
1/4" x 1"L with thread lock
4
94
1/2" Flat Washer
1
96
1/2" Lock Nut
1
107
Weight Selector Pin
2
A.
Slide Weight Stack Cushion (56) on two Guide Rods (51) allowing
approximately 3” of Guide Rod showing below the Weight Stack
Cushion. Insert Guide Rods (51) into the holes in the Rear Base
Frame (1) as shown.
B.
Slide Weight Stack Bottom Plate (55) on top of Weight Stack
Cushions (56).
C.
Place nineteen Weight Plates (66) and the Selector Rod/Top Plate
Assembly (52 & 53) on the Guide Rods (51) as shown. Install
Weight Plates (66) so that the selector pin hole faces forward and
is located on the bottom of the plate. Install the Selector Rod/Top
Plate Assembly (52 & 53) so that the head of the bolt is facing
forward. This gym is supplied with individual weight plate
numbering decals that should be applied to the gym after the
weight stack is assembled.
D.
Slide Guide Rod Holder (50) on the top of the Guide Rods (51)
and attach the Guide Rod Holder (50) to the Rear Top Frame (2)
using the hardware shown. Tighten hardware securely.
E.
Place Weight Selector Pin (107) in the bottom weight plate.
F.
Repeat Steps A-E for the second weight stack.
G.
Attach Pulley Bracket (36) to Rear Top Frame (2) using the
hardware shown. Do not tighten hardware.