Page 8
INSTALLATION INSTRUCTIONS
1
1
• 5mm Hex Key Socket…………………………………...
•
6mm Hex Key Socket……………………………………
1
1
1
• 13mm Box / Open-End Wrench ……………….....
• 13mm Socket……………………………………………
• Torque Wrench…………………………………………
REQUIRED TOOLS:
GENERAL NOTES:
•
Unless otherwise noted Loctite 242/243 or equivalent thread locker must be used on all threaded fasteners. (Do not use
thread locker when a Nyloc nut is used.)
•
All NAUTILUS
®
Strength equipment MUST be secured to the floor using either 10mm or 3/8in. (grade 5 minimum)
bolts.
•
This Installation Instructions Manual must be used in conjunction with the equipment’s Owner’s Manual. The owner’s
manual describes equipment setup and instructs members on how to use it correctly and safely.
•
Some Benches and Racks require at least two people to perform the installation.
Should any component not be present or if you have any operational questions, please refer to your owner’s manual or on the
web @
www.nautilus.com
. Specifically refer to your Nautilus serial number and model number labeled on your equipment.
THREAD LOCKER APPLICATION:
Clean all threads and holes, apply no more than 3-4 drops per bolt.
Thru Holes
Blind Holes
55.5 to 58 (41 to 43)
1.75
10mm
• Torque all hardware to values as specified above, unless noted otherwise.
• See hardware sheet of this manual for fastener sizing information; for reference only.
• Note: All torque values are in N-m unless otherwise stated.
61 to 65 (45 to 48)
1.25
12mm
25.5 to 28.5 (19 to 21)
1.25
8mm
10 to13.5 (8 to10)
1.25
6mm
Torque, N-m (lbs-ft)
Thread Pitch
Bolt Size
Metric Steel Bolts Torque Specifications
PACKAGING REMOVAL:
Carefully remove all packaging materials that wrap the equipment.
DO NOT USE A KNIFE OR BOX
CUTTER AS YOU MAY DAMAGE THE EQUIPMENT.
At this time remove any sub-components from
the pallet or box and set aside for later assembly.
