Nautilus 6 Series, Owner'S Manual

Page: 36 / 42

TROUBLE SHOOTING TROUBLE SHOOTING
F831524--011-00 M-6000A1DC 10208
F831524--011-00 M-6000A1DC 10208
SYMPTOM SYMPTOM CAUSE CAUSE SOLUTION SOLUTION
Console display do not
illuminate
A).No power to treadmill.
B).Console wire is not
connected or
incompletely.
C).Overload, protecting is
started.
D).Console power source
damaged
A).Check the on-off switch is on, switch indicator
shall be light. if not light, check AC power source.
B).Check console wire every connector points
connect correctly, including outward and
connector point insert PINs.
C).Check fuse(near on-off switch) is worked or not,
if worked, push it back, and restart again, if work
please maintenance the running belt and deck.
D).Turn off power then open the motor cover, turn
on the power and check the console power pilot
lamp(LED2) where on the interface PCB, it shall
be light completely, if not, replace it.
Display not completely A).Console damaged.
B).Console source power
unstable.
A).Replace the console PCB.
B).
Turn off the ON/OFF switch, then open
the motor cover. Turn on the power again
to see if the interface power lights up or
not. The interface needs to be changed if
the interface power doesn’t light up or
glitter.
Show SPEED ERROR A).RPM sensor problem.
B).Driver system problem. A).Turn off power and wait 15 seconds then turn
on again, press start, if motor work then show
SPEED ERROR, turn off power then open the
motor cover, check the sensor wire connect
correctly or replace it. If motor not work, see
description of B).
B). Turn off power then open the motor cover,
replace the interface PCB, if not work, replace
inverter.
Show E1 Memory device damaged. Replace console PCB.
Show INCLINE ERR Console can not receive the
incline motor signal or signal
error.
1. Reset power, if incline can be work, check
incline wire and console wire connector
connect well, check every points connect
correctly, including outward and connector
point insert PINs.
2. If wires check ok but still show ERR, replace
the incline motor VR.
3. Reset power, if incline can not be work, check
the incline operate pilot lamps LED4(UP) &
LED5(DOWN) lights up or not when operate
the incline function, if not light, check console
wire or replace interface PCB. If light up,
check the motor is locked or not(maybe
already at lowest position and still move down,
must be re-homing), if not locked, replace
interface PCB.
Show LUBRICATE
DECK Prompt message, that
warning you running belt
need to lubricate. After dropping lubricating oil, press "Stop"
to erase the signal.
If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
34