Service Manual Chapter8. CDU (Cash Dispenser Unit)
©
Nautilus Hyosung, Inc.
All Rights Reserved.
8-29
The Side Guide Setting Specification
▶
The Side Guide Setting Specification
1. Set the Reference Position referring to bill width and other information at the
following Table ‘The Side Guide Setting Position’.
No.
Bill Width
Reference Position
Note
1
Less than 122mm [4.80inch]
122
2
Greater than 122mm [4.80inch] ~
Less than 127mm [5.00inch]
127
3
Greater than 127mm [5.00inch] ~
Less than 132mm [5.20inch]
132
4
Greater than 132mm [5.20inch] ~
Less than 137mm [5.39inch]
137
5
Greater than 137mm [5.39inch] ~
Less than 142mm [5.59inch]
142
6
Greater than 142mm [5.59inch] ~
Less than 147mm [5.79inch]
147
7
Greater than 147mm [5.79inch] ~
Less than 152mm [5.98inch]
152
8
Greater than 152mm [5.98inch] ~
Less than 157mm [6.18inch]
157 US
Dollar
9
Greater than 157mm [6.18inch] ~
Less than 162mm [6.38inch]
162
10
Greater than 162mm [6.38inch] ~
Less than 167mm [6.57inch]
167
The Side Guide Setting Position
Fig. 6.2 Fig. 6.3
2. Put the hook parts of Side Guide into the holes of Guide Assembly Position, and
then push it toward the pick-up assembly direction until you can see the screw hole.
(Fig.6.4)
In case the bill width is greater than 150mm [5.90inch],
Reference Position
Assemble at the same position