Chapter4. Control Electronics Service Manual
4-2
© 2016
Nautilus Hyosung Inc.
All Rights Reserved.
Disassembly Procedure
►
Disassemble the control electronics as follows,
1. Open the upper front door with key.
2. Unscrew the two screws located on the bottom of CE case and remove all cables
and connectors to take out the control electronics.
3. Remove four screws located on both side in the following figure.
4. The following figure is after the cover of the CE unit is removed.
5. To take apart electronic board or card you want to replace, just disconnect cables or
unscrew a couple of fixing screws
6. The assembly order is the opposite of the disassembling order.
