9
1.
After verifying that the main O-ring is in good condition, lightly coat it with the
lubricant provided.
2.
Make sure the O-ring groove located in the rear part of the housing is free
from any foreign material; the groove can be cleaned with the aid of a
microfiber cloth.
3.
Place the main O-ring into the groove, first at the corners, then the whole
perimeter.
4.
Setting up the moisture alarm:
1.
Install the CR2032 battery
provided into the battery
compartment on the circuit
board inside the rear part of the
housing.
2.
Test the alarm by contacting
the two wires near the bottom
of the housing with a damped
cotton bud; the alarm should
start giving out a repeating
“beep” sound along with a
flashing red light. The “beep”
sound and the light should keep
on going for 5 seconds after the
removal of the damped cotton
bud.
