Battery
Door
12mm
Fig.10
Fig.9
Fig.8
Fig.6
OFF
Fig.7
Screw Cap
To charge the battery follow these instructions.
1. Always ensure that the Master Switch is OFF
(See Fig.6).
2. Always ensure that the WAVEMAKER is out of the water,
dry and placed in a dry area.
3.
Use a small coin to unscrew the Screw Cap
counter-clockwise. (See Fig.7).
Charging the Battery
11
12
7. Allow two minutes for any gasses to dissipate.
8. Take out the battery from the Battery Compartment and
place on a level surface.
9. Connect the battery to the Charger (See Fig. 10).
10. Plug Charger into electrical socket/plug, and turn on
the supply.
11. Charging will take 3-4 hours for a fully discharged
battery. When the battery is charging the LED on the
Charger turns RED. When the battery is charged the
LED turns GREEN.
12. Unplug the Charger from the electrical socket/plug.
13. Allow battery to stand for 30 minutes before using it.
14. Unplug the battery from the charger.
15. When ready for use, install the battery and making
sure to insert it the right way round. (See Fig. 11).
16. Make sure the seal and sealing surfaces are clean and
lubricated with silicone grease EVERYTIME (you can
buy this at your local hardware store) before replacing
the Battery Door (See Fig. 12).
4. Pull out the Screw Cap slightly to a maximum of 12mm
ONLY. DO NOT PULL OUT THE SCREW CAP AND
STEM COMPLETELY (See Fig. 8).
5. Press on Screw Cap to release locking mechanism of
Battery Door (See Fig. 9).
6. Pull out Battery Door part to access battery.
