Nautel VS300, Operation And Maintenance Manual

Page: 146 / 229

VS300 Operations and Maintenance Manual Operating the transmitter
Issue 8.0 2016-03-01 Page 2-131
Network Setup - Using the AUI
By entering the VS300’s established IP address into an Internet browser’s address bar, and then
logging into the AUI, you can view and edit the network parameters (see
Figure 2.109 ). You must
have remote control enabled to edit network settings using the remote AUI.
The
MAC Address
and
Status
fields are read-only; they cannot be edited.
You must select Static IP to be able to edit the
IP Address
,
Subnet Mask
,
Default Gateway
and
Nameserver
fields. If you are in DHCP mode, these fields will be assigned automatically.
The
Status
field
i
dentifies the status of the network.
• Running: transmitter is connected to a network and is functioning properly.
• Not Running: transmitter is not connected or is not functioning properly. When in this
state, remote AUI access is not possible.
Figure 2.109: Network Setup Page
Note:
Nautel recommends that the following settings be entered/vetted by a qualified Network
Administrator.
All IP addresses
shown are for
reference
purposes only