Nautel NX5 AM, Operation & Maintenance Manual

Page: 79 / 220

NX5 OPERATION & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 0.1 2015-08-01 PAGE 3.2.59
Editing, Creating and Deleting Presets
When the
Presets
page (see Figure 3.2.48 on page 3.2.66 , Figure 3.2.49 on page 3.2.66 and
Figure 3.2.53 on page 3.2.67 ) is opened from the menu, the
Current Settings
of the transmitter are
displayed. They define the current operational state of the transmitter.
Current Settings
can be edited
and then immediately activated by clicking the
Save
button. In the top banner, an asterisk (*) appears
next to the preset name when the
Current Settings
have changed since the last preset was loaded.
NOTE: Current Settings
are not saved through an ac power cycle; when the transmitter recovers from
an ac power loss, it loads the preset that was last activated.
To edit a saved preset, you must load that preset from the
Presets
page (see Loading Presets, on page
3.2.60 ). If the edited preset was active before it was edited, saving the preset will update the preset,
but the
Current Settings
will not change. In this case, an asterisk appears next to the preset name in
the top banner. To update the operation of the transmitter, re-activate the preset through the top
banner (see
Activating Presets, on page 3.2.60 ).
On the
Presets
page, an asterisk (*) appears next to the preset name in the header when there are
unsaved changes to the preset.
When changes are complete, click the
Save
button or press X to discard. If you are creating a new
preset, click the
Save New
button, enter a nsame for the new preset in the
Save New
prompt and
click
OK
.
Parameters that can be edited are discussed in detail in Understanding the Preset Tabs, on page 3.2.61 .
To remove a preset,
Load
the preset and click the
Delete
button. Users cannot delete the current
"active" (operational) preset or any preset that is referenced in the
Remote I/O
menu as either a
remote input or output, referenced in the Scheduler or used as an audio loss preset. Those links in the
Remote I/O
menu, Scheduler or audio loss preset must be deleted before the associated preset can be
deleted. Click
Cancel
to return to the
Presets
page.
NOTE:
See Preset Examples - IBOC Preset, on page 3.2.68 , Preset Examples - Analog Preset, on page
3.2.68 , Preset Examples - IBOC Preset with Analog Backup, on page 3.2.69 and Preset Examples - DRM
Preset, on page 3.2.69 for sample presets for different transmission modes.