Nautel NX400, Installation Manual

Page: 13 / 89

NX400 Installation Manual Unpacking and positioning
Issue 1.0 2017-06-30 Page 2-1
Section 2: Unpacking and positioning
To install an NX400 transmitter, perform the following tasks:
1. Lift and/or slide the transmitter cabinets off the base of their crates using mechanical
assistance (i.e., a forklift) and/or sufficient manpower. The NX400 is shipped in five main
crates - four transmitter cabinets and a transformer cabinet. Crated and uncrated weights are
shown in Table 2.1 . An additional crate, which contains the ac power disconnect switch, is
also provided.
Table 2.1: NX400 Cabinet Weights
CAUTION:
The NX400 contains adjustable feet that allow leveling of the cabinet
in its final position. ensure the leveling feet are fully retracted (up)
before moving the NX400. failure to do so may cause damage to the
leveling feet and attached metalwork.
WARNING:
Do not attempt to move the transmitter cabinets or the transformer
unless sufficient manpower or mechanical assistance is available to
move it into position without damaging the cabinet or causing injury
to personnel.
Cabinet
Crated Weight
kg (lbs)
Uncrated Weight
kg (lbs)
687 (1515) 567 (1250)
687 (1515) 567 (1250)
2155 (4750) 2056 (4533)
Control Cabinet
Inner, Output and Side Cabinets
Power Transformer Cabinet
Ac Power Disconnect Switch 191 (421) 157 (347)