Nautel NV30LT-N, Operation & Maintenance Manual

Page: 90 / 226

NV30LT-N OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.72 VERSION 0.1 2015-03-01
SCA Settings
When you select
SCA Settings
from the
Preset
editing options screen, you can edit various SCA
parameters (see Figure 3.2.54 ).
Figure 3.2.54: SCA Settings menu
Use the up and down buttons to move the cursor to the desired SCA setting and then press the right
button to enable editing of the parameter.
Figure 3.2.55 shows the editing screens for the
SCA Settings
menu. Within any of the editing screens, use the up and down buttons to edit or toggle a parameter
value, noting the minimum and maximum limitations indicated at the bottom of the display. When
complete, press the accept (checkmark) button to save the change. Press the cancel (
X
) button to
discard changes and return to the previous menu.
If you select Internal SCA1 or Internal SCA2, there is a sub-menu that contains additional SCA settings
(see
Figure 3.2.56 on page 3.2.73 ).
Figure 3.2.55: SCA Settings editing screens
Use the up and down buttons to select a level between 1 and
5 V peak-to-peak (in 0.01 V increments), then press the ac-
cept (checkmark) button to save the change. Press the cancel
(
X
) button to discard changes and return to the previous
menu. Default level is 3.5 V pp.
Use the up and down buttons to select ON or OFF, then press
the accept (checkmark) button to save the change. Press the
cancel (
X
) button to discard changes and return to the previ-
ous menu. Default setting is OFF.
Use the up and down buttons to select the desired parameter
for editing. See
Figure 3.2.56 on page 3.2.73
for more
details. Press the accept (checkmark) button to enter the
sub-menu for that parameter. Press the cancel (
X
) button to
return to the previous menu.