Nautel NV Series, Software Update Procedure, Page: 5 / 10

NV Series – Software Update Procedure
Page 3
IS09004D Issue 1.1
4.3 Transfer software upgrade file
to Transmitter
(a) If using a laptop, connect the laptop
network interface card to the
transmitter LAN port (A1J21 on the
control/interface PWB) using a CAT5
Ethernet cable. Open Internet
Explorer and search for 10.10.10.2.
The transmitter login screen should
appear.
(b) If using a network computer, open
Internet Explorer and search for the IP
address recorded in step 4.1 (b). The
transmitter login screen should
appear.
(c) At the transmitter login screen enter:
User:
Nautel or ****
Password: none (default) or ****
**** denotes an alternate user
assigned password and user name of
an account that has Super User or
Read/Write permission level.
(d) Navigate through the AUI to
Menu /
Software Configuration / Upgrade
Software and press Browse . Locate
the software update *.tgz file and
press Upload to load the file into the
transmitter boot image list.
(e) Proceed to paragraph 5.
5 FLASHING TRANSMITTER WITH
UPGRADE SOFTWARE
(a) Set the transmitter to its
RF Off state.
(b) Set the transmitter for
Local control.
Perform the following steps locally (in
front of the transmitter AUI).
(c) Go to the AUI
Menu / Software
Configuration / Upgrade Software
screen and select the update *.tgz file
from the boot image list (should
highlight in blue) and press
Begin
Flash .
CAUTION
Note the red warning text at the top of
the AUI screen – do not leave this page
until the flash process is complete.
(d) After a successful load ( boot status
indicates 100% complete and notes
that cubes should be reset
) press
Reset and go to the Maintenance
screen in Menu / Software
Configuration and select Reboot
AUI .
(e) This completes the software upgrade.
Restore the former network settings
on the transmitter and laptop as
required [see step 4.1 (b)].
(f) From the transmitter AUI, go to
Menu /
Software Configuration / Network
Setup , and set the network settings
(IP address, Subnet Mask, Default
Gateway) recorded in step 3 (a).
(g) Login and repeat step 2 (a) to
determine if the current version is the
same as the upgrade version – this
confirms the upgrade was successful.
(h) If the upgrade was not successful,
repeat steps 5 (a) through 5 (g),
except in step 5 (d), cycle the ac
power (switch off, then on) instead of
selecting
Reboot AUI . If still
unsuccessful, contact Nautel.