Nautel GV5, Operation & Maintenance Manual, Page: 162 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 0.2 2014-07-23 PAGE 3.2.145
Notifications
The Notifications page (see Figure 3.2.124 ) provides a means for the transmitter to issue emails
triggered by user defined alarm events. If you use this feature, you must also configure an email (see
Email Configuration, on page 3.2.143 ).
Figure 3.2.124: Notifications page
To configure the notifications feature, perform the following steps:
1. Pre-existing notifications are displayed in the Notifications list (e.g., “LVPS Failures”. Press
Add
to
create a new item for notification, press
Update
(after highlighting an existing item) to edit an
existing item or press
Delete
to erase an item.
2. When you press
Add
or
Edit
, the screen in Figure 3.2.125 on page 3.2.146 will appear. This screen
allows you to add or edit a
Notification Name
,
Recipient Email
, and define the alarm list by
Device
type (Controller, Exciter A or B, Rack #or RF Module #). Add or remove alarms by moving
them (using the >> and << arrow buttons) from the Available Alarms list to the Selected Alarms
list. An email is issued when any alarm in the Selected Alarms list is active.
3. When complete press the
OK
button to accept changes or the
Cancel
button to discard changes
and return to the
Notifications
page.