natus Olympic Warmette 48, Instruction Manual, Page: 18 / 50

2-4 Olympic Warmette Models 48/49 and 55/56 Instruction Manual
Inspecting the Heater
Figure 2.5 Screw locations inside Warmette door
3
Pull out and remove the front panel (see Figure 2.6) .
Figure 2.6 Removing the front panel
4
Unhook and remove the plenum hold-down spring and bridge (see Figure 2.7).
Figure 2.7
Blower/Filter assembly
5
Separate the plenum from the casing.
6
Lift the plenum, and then unscrew the heater from its socket. Ensure that the
socket cap is tight, and then screw the heater firmly back into place.
7
Reinstall the plenum. Ensure that the plenum and case are seated firmly. Install
the plenum hold-down spring and bridge.
8
Reinstall the front panel and tighten the screws.
9
Test the Warmette for proper operation (see Testing the Warmette ).
Door stop
Screws (4)
Access panel
NOTE
#
Push together the hold-down bridge and the spring, and then separate them.
Plenum
Plenum hold-down
spring
FRONT
Blower
Plenum hold-down
bridge
BACK
Terminal strip