Page
13
To change unit function:
To enter the feature setting mode
, press and hold “Power” and “Select” button
together for about 5 seconds until a beep is sounded. Display will show current
inverter setting as “In0 or In1 or In2”
Press and hold “Select” button for 1 second to toggle between the three settings.
Once the desired setting is selected, press and hold “Power” button for 1 second to
set the desired setting and carry on with setting the other feature.
Display will show current charger setting as “Ch0 or Ch1”
Press
and hold “Select” button for 1 second to toggle between the two settings.
Once the desired setting is selected, press and hold “Power” button for 1 second to
set the desired setting and carry on with setting the other features.
Display will show current a
larm setting as “AL0 or AL1”.
Press and hold “Select” button for 1 second to toggle between the two settings.
Once the desired setting is selected, press and hold “Power” button for 1 second to
set the desired setting and carry with setting the other features.
Display will show “Fd” factory default setting. If you desire to use the factory setting,
press and hold „Power‟ and „Select‟ button together for 5 seconds to exit the setting
mode. If you wish to keep all the previous settings on inverter, charger and alarm,
just press „Power” button for 1 seconds and press and hold „Power‟ and „select‟
button together for about 5 seconds to exit the feature setting mode.
Note: Press and hold „Power‟ and „Select‟ button together for 5 seconds at any time to
exit the feature setting mode. See feature setting chart below.
