5
www.naturalozone.co.nz
IMPORTANT information
Important Statement
We reserve the right to revise this clause at
any time, without notifying each of the users of
this product separately.
We reserve the right to revise parameters
and specifications in this manual. We will
endeavor to update documents with new and
updated information. All these changes will be
present in new editions, but not announced
in advance. The company or company
manufacturer is liable for all information within
this manual. All the illustrations in this manual
are intended as a guide only and may differ
from new and updated products. Information
about the technique and the product is only
accurate at the time of publication and is
liable to change. There may be deviations
between the descriptions in this manual and
your product, which is subject to change at
any time.
Warnings
D
o not use this product near high-frequency
or electro-medical electronic equipment,
because electric waves may cause faulty
or incorrect operation of the high-precise
electronic equipment and other problems.
Special attention should be paid to the
following equipment as follows: hearing
aid, pacemaker and other electro-medical
equipment, fire detector, other high-frequency
automatic control equipment.
Do not dismantle or reconstruct this product,
as this may lead to damage, electrical leakage
and faults in the electrical circuit.
Do not allow this product to get wet or be
subject to high moisture environments as this
may lead to electrical leakage and other faults.
To avoid damage on the surface of equipment,
volatile solution or organic solvent should not
be employed in cleaning.
To eliminate fire risk it is required that a
qualified special grounding cable, reliable
grounding, and wire with enough capacity are
used. All staff must be trained in the correct
maintenance of the equipment.
While using ozone, workers are not permitted
to work in a space with high concentration of
ozone. To work in a space with over-standard
ozone concentration, protective measures
must be taken.
Environmental Requirements
• T
here shall be no flammable, no explosive
gas and no conductive powder dusts
in the room. It’s not permitted to install
the equipment in a place where alkaline
air is easy to leak or there is the risk of
explosion.
• Indoor installation only, with electrical
power supply of 220V/50Hz AC power
(110V /50-60Hz).
• Ambient temperature: -10°C~37°C
• Ambient humidity: ≤ 55%
• The equipment installation must be
installed on a horizontal surface and the
equipment should always be placed on a
stable surface on the ground.
• If there is a fan or air conditioner available,
it is helpful to run concurrently with the unit.
