▪
Relative (Offset): This mode is similar to the Relative mode explained above, with the differ-
ence that here the values sent for the “+1” and “-1” messages are 65 and 63, respectively
— in other terms, they are centered around 64 instead of 0. This is well suited for some
particular software implementations. As in Relative mode, a
Step
parameter defines the in-
crement to use, and a
Resolution
parameter adjusts the sensitivity of the control element
to your actions.
KOMPLETE KONTROL S-SERIES: The
Resolution
parameter is not available for
Knobs 1–8.
The appropriate mode mostly depends on your target’s requirements! Please refer to the
documentation of your target to know which mode is best suited.
Display Menu (MASCHINE Controllers and KOMPLETE KONTROL S-SERIES Only)
For the types Control Change (Absolute mode only), Poly Pressure, Channel Pressure, and
Pitchbend, the knobs show a
Display
menu that lets you decide how the parameter should
ap-
pear
on the display(s) of your controller: with the zero in the middle (
Bipolar
) or at the begin-
ning (
Unipolar
, by default) of the interval. This is up to you, since it depends on what you plan
to control with this assignment.
The Program Change type does not offer this parameter, since it is always unipolar.
25.6.9 Assignments for Touch Strips – Position Action
The assignments described here are valid for following control elements:
NI Controller
Control elements
TRAKTOR KONTROL X1 MK2, S5, S8, D2 Touch Strip (Position action)
MASCHINE JAM
Touch Strip (Position action)
Reference
MIDI Message Parameters
CONTROLLER EDITOR - Manual - 329
Summary of Contents for komplete kontrol s series
Page 1: ......
