Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
800.482.1717
.
Fierce
™ Assembly Instruc
tion
Required Tools
5mm Hex Key (Included)
Package Contents
Qty.
1
1
1
1
Back assembly
Plastic base
Gas lift cylinder
Seat assembly
Hardware Kit:
-
M6X
14
hex head bolts
-
M6X30 hex head bolts
-
M8X
3
0 hex head bolts
Right arm assembly
Left arm assembly
Weight Balance Control
Mechanism
Set of 5 casters
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part #
3216439
Rev,
A
Printed in U.S.A
© 2013 Kimball International, Inc.
Product Line
Fierce
™ Task Chair
1
Place mesh seat assembly upside down on an elevated flat surface.
Position the right and left arm assemblies on the bottom of the
seat as shown in Figure A. Note: To assure proper assembly of
the right and left arms, each arm should angle toward the front of
the seat, not rearward. Using the 5mm hex key wrench, secure each
arm with (
3
) M6 X 30 hex head bolts as shown in Figure A.
!
Assemble units as described herein only. All screws and bolts
must be tightened securely and checked periodically after
assembly. Failure to assemble or to secure parts properly may
result in assembly failure and personal injury.
Figure B
2
4
6
3
1
1
1
1
Figure A
3
Position control mechanism on bottom side of mesh seat assembly to
match the back 4-hole configuration. Using the 5mm hex key wrench,
secure the control mechanism to the seat assembly using (4) M6 X
14
hex head bolts as shown in Figure B.
Position the mesh back assembly to the corresponding hole
configuration on the back bottom of the control mechanism. Using the
5mm hex key wrench, secure the mesh back assembly with (3) M8 X
3
0
hex head bolts
as shown in Figure C.
Figure C
