Assembly Instructions
Captivate™ Series
Bridge Assembly
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.
C A S E G O O D S
4
Move desk and credenza into desired
positions. Level units. Place bridge
worksurface with modesty attached
on mounting brackets. Adjust units so
all worksurfaces are flush with no gaps,
and that modesty panel is flush with no
gaps with end panels of desk and
credenza.
Attach bridge worksurface to all
mounting brackets with provided
#10 x 3/4” panhead screws, four
(4) per bracket.
Attach bridge modesty panel to
wood mounting rails using three (3)
of the provided #8 x 1 1/4” panhead
screws in each mounting rail
(Figures E & Figure F).
3
Figure D
Place bridge worksurface face down on a
smooth, clean, soft surface. Align modesty
panel cleat holes with predrilled holes on
edge of worksurface rim. This will leave an
offset of approximately 25/32”. Attach
modesty panel cleats to worksurface using
six (6) #8 x 1 1/2” panhead screws
(Figure D).
Figure E
Attach bridge to
mounting brackets
Bridge
Modesty Panel
Flush
Desk or Credenza
End Panel
Figure F
25/32”
Wood
Mounting Rail
#8 x 1 1/4”
Panhead Screws
