National Vendors shoppertron 431, Operator'S Manual, Page: 25 / 74

Shoppertron
TM
Operator’s Guide
4310114 Page 21 July, 2003
SELECT COIN MECHANISM AND OPTIONS
1. Press , then press until the current COIN MECHANISM is
shown in the display. Press to choose the desired coin mechanism.
Your choices are:
MDB MECH, EXEC MECH, DUMB MECH
or
NO MECH
NOTE
Choose EXEC MECH even if the exec device is a card reader.
2. CONTINUE.
SELECT BILL VALIDATOR AND OPTIONS
1. Press , then press until one of the following is displayed:
2. Press to choose the desired option.
3. CONTINUE.
NO DBV
- No bills will be accepted or there is no bill validator installed
(you can exit the function).
SER.1.2.5.10.20
- The serial bill validator is selected and will accept $1, $2,
$5, $10, and $20 bills. Use BILL SELECTION METHOD
below to change the bills that will be accepted.
PULSE DBV
- The pulse bill validator will accept $1 bills.
MDB.1.2.5.10.20
- A standard MDB bill validator is selected. It will accept $1,
$2, $5, $10 and $20 bills. Use BILL SELECTION METHOD
below to change the bills that will be accepted.
BILL SELECTION METHOD:
The standard $1, $2, $5, $10 and $20 bills are enabled by
pressing the 1, 2, 5, 6, or 7 key(s), respectively, to display
which bill(s) will be accepted.
MDB. <*>
-
An MDB bill validator that accepts non-standard bills or
tokens is connected and operating. Press to enter
list of bills. See "Initial Setup Of Non-Standard Bill Vali-
dator" on page 22.