L M X 2 5 3 1 L Q 1 9 1 0 E E V A L U A T I O N B O A R D O P E R A T I N G I N S T R U C T I O N S
CodeLoader is set up to load the registers and initialize the part in the correct
way. R5 (INIT1) and R5 (INIT 2) are just the R5 register being used to properly
initialize the part. So a single CNT+L should load the part.
The port setup tells CodeLoader what information goes where. If this is wrong,
the part will not program. Although LPT1 is usually correct, CodeLoader does
not autodetect the correct port. On some laptops, it may be LPT3.
10
