10
Ignition over-ride (optional accessory)
CAUTION
Insert the charger quick-connector into the charge port
labeled "NL5 CHARGER" until it clicks securely.
This port can support up to 10A charge current.
The Power Pack has a charge port specifically for use
with National Luna Intelligent Battery Chargers.
Make sure the main breaker switch is in the ON position
during charge.
In order to connect other brands of chargers to this input,
a quick-connector cable is available separately.
Larger-power inverters should be connected directly to
the battery terminals.
When using chargers or inverters connected to the
AUXILIARY IN/OUT plugs, the main switch must be ON.
In order to use higher-power battery chargers with
currents greater than 10A or other brands of chargers, it
is recommended to connect to one of the AUXILIARY
IN/OUT plugs. These plugs have a 50A continuous
rating.
AC Inverters can be connected to the AUXILIARY
IN/OUT plugs for powers up to 600W.
Plug the larger end into a socket that provides a positive
voltage only when the ignition of the vehicle is ON.
The IGNITION SENSE port allows the Power Pack to support
vehicles where the charge voltage drops very low or is very
erratic.
This may be the case in some vehicles with "Smart
Alternators".
Plug the small end of the over-ride cable into the
IGNITION SENSE port.
Only use the IGNITION SENSE feature if the vehicle alternator voltage is below 13.2V under normal
conditions.
Connecting the IGNITION over-ride to a permanent 12V source may result in excessive discharge of
the MAIN battery.
IGNITION
SENSE
NL5 CHARGER
Connecting external Battery Chargers
High-current Chargers and Inverters
