Chapter 3
Configuration and Default Settings
VXIpc 770/870B Series User Manual
3-18
ni.com
You can use the SMB tab to configure the options associated with the SMB
connectors on the front panel of your VXIpc controller. Table 3-7 lists the
default settings for this tab on your VXIpc controller.
VXI-MXI-2 Default Settings
This section summarizes the software default settings for the VXI-MXI-2.
This information is included for your convenience in case you have any of
these modules in your system.
Table 3-7.
VXIpc MAX SMB Tab Default Settings
Setting
Default Value
Clock 10 Settings: Enable 50 Ohm
Termination
Checked
Table 3-8.
VXI-MXI-2 General Tab Default Settings
Setting
Default Value
Common Board Configurations
Current Board Configuration
Table 3-9.
VXI-MXI-2 Device Tab Default Settings
Setting
Default Value
Logical Address Selection
Use DIP Switch to Set the
Logical Address
Shared Memory: Address Space
A24
Shared Memory: Requested
Memory
16 KB
Operate in Interlocked Mode
Checked
Table 3-10.
VXI-MXI-2 MXI-2 Bus Tab Default Settings
Setting
Default Value
Bus Settings: Bus Timeout
1 ms
System Controller
Auto Detect
