Chapter 3
VXIpc 700 Series Configuration and Installation
©
National Instruments Corporation
3-7
VXIpc 700 Series User Manual
6.
Change jumper W7 back to the position shown in Figure 3-5a.
7.
Turn on the computer. If the computer does not boot with this
configuration, you will have to repeat these steps, modifying your
configuration until a final configuration is reached.
Installed System RAM
The 16 MB of installed RAM is factory configured per customer order.
You can change the amount of installed RAM on the VXIpc 700 Series by
installing DRAM SIMMs. Refer to Appendix A,
information on SIMMs.
Configuring the PC
This section describes how to configure the following options on the PC:
•
System CMOS
•
Ethernet power-on defaults
System CMOS
The VXIpc-700 contains a backed-up memory used to store BIOS defaults
and configuration information.
To clear the CMOS contents, simply short the pins of W3 as shown in
Figure 3-6b.
Caution
Do not keep these two pins short-circuited. The computer cannot sustain the
CMOS memory when the power is turned off if you leave these two pins shorted.
Figure 3-6.
System CMOS
!
W3
W3
a. Normal Operation
(Default)
b. Clear CMOS
Contents