![background image](http://html1.mh-extra.com/html/national-instruments/tc-2095/tc-2095_calibration-procedure_708757003.webp)
©
National Instruments Corporation
3
TC-2095 Terminal Block Calibration Procedure
Verification Procedure
This section contains step-by-step instructions for verifying the
performance of the temperature sensor on the TC-2095 terminal block.
Verifying Temperature Sensor Performance
Complete the following steps, while referring to Figures 1 and 2, to verify
the performance of the temperature sensor on the terminal block.
1.
Connect a +5 VDC power source to the terminal block.
a.
Hold the terminal block horizontally upright and view it from the
rear. The terminals on the 96-pin DIN connector are designated
as follows:
–
Column A is on the bottom, Column B is in the middle,
and Column C is on the top.
–
Row 1 is on the right and Row 32 is on the left.
Figure 1 illustrates the connector pin assignments. Individual pins
are identified by their column and row. For example, A3 denotes
the terminal located in Column A and Row 3. This corresponds to
the labeling of the pins on the front connector of a mating SCXI
module.
Figure 1.
TC-2095 Connector Pin Assignments
1
O
N
2 3 4 5 6 7 8
1
O
N
2 3 4 5 6 7 8
1
O
N
2 3 4 5 6 7 8
1
O
N
2 3 4 5 6 7 8
1
O
N
2 3 4 5 6 7 8
1
O
N
2 3 4 5 6 7 8
1
O
N
2 3 4 5 6 7 8
1
O
N
2 3 4 5 6 7 8
C1
B1
A1