©
National Instruments Corporation
25
DIN160 Cable Installation Instructions
Accessories
Visit
ni.com
for information about the following accessory.
Caution
You must install mating connectors according to local safety codes and standards and
according to the specifications provided by the connector manufacturer. You are responsible for
verifying safety compliance of third-party connectors and their usage according to the relevant
standard(s), including UL and CSA in North America and IEC and VDE in Europe.
Refer to Table 14 for information about third-party accessories.
Table 13.
NI Accessory for the DIN160 Cable
Accessory
Part Number
NI TBX-50 terminal block, with screw connection and
50 position D-Subminiature pin strip
779305-01
Table 14.
Third-Party Accessories for the DIN160 Cable
Accessory
Manufacturer
Part Number
VARIOFACE module, with screw connection and
50 position D-Subminiature male connector
Phoenix Contact
FLK-D50 SUB/S
Right-angle 50 position male D-SUB connector
*
Amp
747497-4
*
Small quantity orders are available from Digi-Key Corporation (part number A23398-ND).
