
3
MTEMP
Thermocouple
- (red)
+ (white)
Thermocouple
This wire grounds the
thermocouple to the
chassis ground of the
terminal block.
Chassis Ground
- (red)
+ (white)
MTEMP
a) SCXI-1300
b) SCXI-1303
Figure 2. Connecting a Thermocouple to Channel 0 of the SCXI Terminal Block
Step 2. Assemble Your SCXI System
A. Configure the SCXI-1102 Module and Terminal Block—Most configuration
settings of the SCXI-1102 are set via software. The SCXI-1102 does include
one jumper, W1, which you should leave in the factory-default position
(position P). You do not need to modify the setting of W1 jumper unless you
are daisy-chaining multiple SCXI chassis and a cable is attached directly to
the SCXI-1102.
Note:
The SCXI-1300 and SCXI-1303 include a jumper to select the MTEMP or DTEMP channel
for the cold-junction sensor input. When used with the SCXI-1102, the position of this
jumper is irrelevant; MTEMP and DTEMP are connected internally in the SCXI-1102.
B.
Insert the SCXI-1102 module into your SCXI chassis.
C. Cable SCXI module to your DAQ board—If you are using a plug-in DAQ
board, connect the SCXI-1102 to your DAQ board using the appropriate
SCXI-134X cable assembly.
If you are using the SCXI-1200 module, install the module into your SCXI
chassis and connect the SCXI-1200 to the parallel port of your PC, using the
cable included in the SCXI-1200 kit.
D. Attach terminal block—Finally, plug the SCXI-1300 or SCXI-1303 terminal
block onto the front of the SCXI-1102 module.
Summary of Contents for SCXI SCXI-1102
Page 10: ......