INSTALLATION GUIDE
NI 1357/1358/1359
SCXI Controller/Adapter Kit
This document describes the components, installation, and configuration
of the National Instruments SCXI-1357/1358/1359 and the
NI USB-1357/1358/1359 controller/adapter kits. The SCXI kit connects
a switch controller to an SCXI switch module; the USB kit connects a
computer to an SCXI switch module. Both SCXI and USB kits create
a high-voltage analog backplane and share high-voltage signals among
switches.
Introduction
Note
Both SCXI and USB kits connect to an SCXI switch with a 10-pin rear connector.
Refer to the
NI Switches Getting Started Guide
to determine the switches and switch
controllers that your kit supports.
The NI 1359 kit (2 slots) consists of the following components:
•
NI USB-1359
(2-slot high-voltage analog bus (HVAB) backplane adapter with
USB connector)
or
NI SCXI-1359
(2-slot HVAB backplane adapter with 9-pin DIN connector)
•
SH9MD-9MD cable (SCXI kits) or USB cable (USB kits)
The NI 1358 kit (12 slots) consists of the following components:
•
NI USB-1359 or NI SCXI-1359
•
One 8-slot HVAB backplane adapter
•
NI SCXI-1359
™
̭͈Ρ΅νιϋΠ͉ͅȂུࢊβȜΐ͜܄̞̳ͦ̀͘͘ȃ
