background image

Summary of Contents for SCXI-1348

Page 1: ...le needs The SCXI 1348 cable assembly consists of an adapter board and an NB4 50 conductor shielded ribbon cable that connects the adapter board to a DIO 32F data acquisition board The adapter board converts the signals from the DIO 32F I O connector to the pinout that a digital SCXI module rear signal connector uses To extend the unconverted signals of the DIO 32F to another module or to an SCXI ...

Page 2: ...le user manual 3 Plug the front connector of the SCXI 1348 into the rear signal connector of the SCXI module A comer of the adapterboard will enter the upper board guide of the chassis 4 Securethe SCXI 1348 adapterboard by screwing the two screws through the rear panel of the adapterboard and into the threadedstrips in the rear of the SCXI chassis 5 Connect one end of the 50 pin shielded ribbon ca...

Page 3: ...nnector Connection The finished installation should look like Figure 3 Figure 3 Installed Cable The following table lists the way that the SCXI 1348 translatespins from a DIO 32F board to the SCXI module 0 National Instruments Corporation XXI 1348 Cable Assembly Znstallation Guide ...

Page 4: ...2 DIOCO DIOC6 bIOC4 DIGGND DIGGND DIGGND DIGGND DIGGND ACK2 IN2 OUT2 REQ2 ACKl IN1 OUT1 REQl DIOA4 DIOA6 DIOAO DIOA2 DIOAl DIOA3 DIOA7 DIOAS DIOBS DIOB2 DIOB7 DIOB6 DIOBO DIOB3 DIOB4 DIOB 1 Module Connector Pin t ti E 44 38 5 13 11 15 yy tr 10 12 14 16 50 it 30 32 18 z x 43 45 41 z7 17 19 23 29 All DIG GND pins are connected to each other on the SCXI 1348 adapter board SCXI 1348 Cable Assembly Ins...

Reviews: