Appendix E
SCXI-1163 Cabling
© National Instruments Corporation
E-9
SCXI-1163 User Manual
Table E-4. SCXI-1163 and DIO-96, AT-MIO-16D, and AT-MIO-64F-5 Board
Pinout Equivalences (Continued)
Pin
SCXI-1163 Rear Signal
Connector
DIO-96
Board
Equivalent
AT-MIO-16D
Board
Equivalent
AT-MIO-64F-5
Board
Equivalent
Serial
Parallel
67
In (15)
CPB7
PB7
69
In (14)
CPB6
PB6
71
In (13)
CPB5
PB5
73
In (12)
CPB4
PB4
75
In (11)
CPB3
PB3
77
In (10)
CPB2
PB2
79
In (9)
CPB1
PB1
81
In (8)
CPB0
PB0
83
In (7)
CPA7
PA7
84
In (31)
DPA7
85
In (6)
CPA6
PA6
86
In (30)
DPA6
87
In (5)
CPA5
PA5
88
In (29)
DPA5
89
In (4)
CPA4
PA4
90
In (28)
DPA4
91
In (3)
CPA3
PA3
92
In (27)
DPA3
93
In (2)
CPA2
PA2
94
In (26)
DPA2
95
In (1)
CPA1
PA1
96
In (25)
DPA1
97
In (0)
CPA0
PA0
98
In (24)
DPA0
100
DIG GND
GND
DIG GND
GND
All other pins are not connected on the SCXI-1163.
SCXI-1351 and NB5 Cable Installation
Follow these steps to install the SCXI-1351:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module in the chassis.
3. Connect the positions 1 through 50 connector (or 51 through 100, as appropriate) of the NB5
cable to the male breakout connector on the SCXI-1351.
4. Plug the mounting bracket connector onto the module rear signal connector (see Figure E-2).
An alignment tab on the bracket will enter the upper board guide of the chassis.
5. Screw the mounting bracket to the threaded strips in the rear of the chassis.
6. Connect the 100-pin connector of the NB5 cable to the board.